THERMODYNAMICS - ENTROPY AND THE SECOND LAW - HEAT CYCLES NC State University Faculty Access

Previous Next

Jensen Steam Engine
# 4F30.20


Description: The steam engine runs on steam pressure made by heating water in a boiler the same way water is boiled in a tea kettle. The first practical steam engines were built about 1700 and were used to pump water. Over the years steam engines where built to operate many types of equipment from autos, such as the Stanley Steamer, to farm tractors, trains and ships. The steam engine reached its peak use around 1900.

Instructions: Open the whistle to vent air. Remove safety valve and pour water (preferably warm or hot) into boiler until gauge glass shows 1/2 to 2/3 full. Check level by lifting one end of boiler so as to actuate water in boiler. When water again is steady, glass will show correct level. Replace safety valve, making sure washer is in place. Steam pressure will develop after several minutes as indicated by water or steam appearing at the exhaust or whistle. Rotate the flywheel to start. When water disappears in gauge glass turn off current.

Hazards: Relieve boiler pressure through whistle before removing safety valve to fill boiler.

Purchased/Built: purchased

Setup Time: 1 hour

Quant. in Demo Room: 1

Source: Central Scientific

Demo References
Hilton H-5b.3 A small steam engine powers a small electric generator.
Freier and Anderson Hn-3 A small steam engine runs from a small alcohol lamp.

Keyword Search:
complete words only, or parts of other words?

Home Manual Demo Suggestions

NCSU Physics Demonstrations
© 2010, North Carolina State University Department of Physics. The design of this site nor the
contents may be copied without the express written permission of the NC State University Department of Physics.


WebDemo
North Carolina State University
All Rights Reserved, 2011